Alpet D2 Surface Sanitizer - 12 / 1 Quart

Alpet® D2 Sanitizer is a ready-to-use, no-rinse, alcohol/quat sanitizer for food contact surfaces and disinfectant for non-food contact surfaces. Alpet D2 Sanitizer is highly evaporative and non-corrosive, making it ideal for water sensitive equipment and low-moisture environments. Alpet D2 sanitizes in 60 seconds and disinfects in 5 minutes. Case of 12 / 1 quart sanitizer in spray bottle.

Manufacturer Specifications:

• Kills 99.999% of bacteria and viruses
• Safe for food contact surfaces
• Highly evaporative / no rinsing required
• Will not impart taste onto food
• Ready-To-Use - no dilution / no mistakes
• Non corrosive to tools and metals
• Safe on most plastics - test on a small area prior to use
• Works where normal sanitizers cannot
• 60 second contact time
• Part Number - SS10003

Safe

• Approved for Food & Non-Food Contact Surfaces
• Meets Code of Federal Regulations Section 21CFR178.1010
• Meets previously accepted USDA D2 classification (no rinse sanitizer)
• NSF Approved D2 classification
• Kosher & Pareve Certified
• EPA Registered # 73232-1

Usage:

Wash and rinse all articles thoroughly, then apply this product. If the article cannot be washed and rinsed, clean thoroughly in an appropriate fashion, then apply this product. Apply with a sponge, cloth, or mechanical sprayer, or by total immersion. When applied with a mechanical spray, spray should be coarse. Surfaces must be sprayed until thoroughly wet. Treated surfaces must remain wet for 1 minute. Apply to hard surfaces by sponge, cloth, brush or coarse spray. Surfaces should remain wet for at least one minute followed by adequate draining and air-drying.

This product in an effective sanitizer and disinfectant against the following pathogens on hard, non-porous surfaces:

Material Safety Data Sheet: Alpet D2 Sanitizer MSDS

Note: This ORM-D consumer commodity item cannot be shipped via Air and can only be shipped by ground services in the lower 48 states only.